English English
Home > News > Industry News
Industry News

Treatment of Adhesive Tape residue

2022-09-19
Introduction of Tape residue

Usually according to the use, known as: rubber belt, high pressure waterproof self-adhesive belt, high pressure rubber belt, rubber insulation belt and so on, most of the black color. According to the different raw materials, divided into: natural rubber Adhesive Tape, butyl rubber Adhesive Tape, ethylene propylene rubber Adhesive Tape, silicone rubber Adhesive Tape and so on. 

Adhesive Tape is mainly used for insulation, sealing and waterproofing of wire and cable joints, and also for protection, repair and sealing of pipelines. Among them, butyl rubber Adhesive Tape has the best waterproof performance, which can be used for underwater wire and cable main insulation repair; Ethylene propylene rubber Adhesive Tape and natural rubber Adhesive Tape are mostly used in the air and exposed to the air wire and cable insulation waterproof protection, as well as communication cable joints waterproof protection; Silicone rubber Adhesive Tape is mostly used in high temperature environment above 150℃.

Stretch the tape 200% and wrap it in half lap. PVC electrical tape is wrapped around the outer layer of the Adhesive Tape for external protection and better effect. Adhesive Tape with insulation, waterproof, sealing, high pressure resistance, usually 10KV-35KV high voltage. 


Adhesive Tape


How to clean up the residual Adhesive Tape

1.Use an eraser. An eraser can rub off many marks, as well as marks on scotch tape. Rub it as slowly as possible, and repeatedly rub it to remove it. It should be noted that some colored parts that are easy to fade can also rub off, so be careful to use them.

2.Imprinting for a long time, if a long time, then the general offset printing will be very hard, very strong. In this way, you can use a towel moistened with warm water to gently cover the offset printing, and then take the wet towel down after a while. Just wipe it slowly. It should be noted that this method is not recommended if the coating material is not water-able.

3.Alcohol wipe, gently repeated wipe on it. It is important to note that when using safety, if you are worried about fading, do not use alcohol this method.

4.Dishwashing liquid, sometimes dishwashing liquid can also remove offset printing. You can use a cloth to dip some dish soap and then wipe offset printing.

5.Nail polish remover, the nail polish remover used to clean nail polish, sometimes can also remove offset printing. It is usually nail lotion, because there are some chemical ingredients in it, so the effect is good.

Previous:

Waterproof effect of Heat Shrinkable Double-walled Tube

Next:

Introduction of 110kV Cable Accessories
X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
Reject Accept