General steps for the installation of Cold Shrinkable Termiantion Kit

Check the installation site - Prior to installation, check that the installation site for the cable termination kit is suitable and complies with applicable codes and standards.

Prepare the cable - Clean and prepare the exposed cable end by removing the outer jacket, cleaning the insulation surface, and roughening it with abrasive paper.

Install the breakouts - Install the breakout components that come with the kit to the power cable, if applicable.

Slide the termination components - Slide the cold shrinkable termination components, such as the skirt, insulation tube, and stress cone over the prepared cable end.

Position the termination components - Position the termination components according to the manufacturer's instructions.

Apply mechanical stress-relieving components - Apply any supplied stress-relieving components, such as stress cones or adhesive, to secure the components.

Inspect - After the termination installation is complete, inspect the installation to ensure that all components are properly installed, the cable seals are tight, and that the cable is re-jacketed, as required.

Cold shrinkable termination kits offer a simple and effective means of sealing cables, even with limited space or access. They don't require heat-shrinking and can be safely installed without special equipment. Please note that the steps provided are meant to be a general overview and may not be applicable to all situations.