Rear Connector Overview

The Rear Connector can be use together with the Front Connector and some other Rear Connector, it can be provide more branches, and they can not together with the bushing directly, cover the back protection cap on the end of the blanking vover.

Performance

The Rear Connector provides a fully screened and fully submersible separable connection when mated with proper bushing or plug. It can be used under the circumstances. Built-in capacitive test point to determine the circuit status or install a fault indicator. No minimum phase clearance requirements. For mounting can be vertical, horizontal, or any angle in between.

Product Structure

1.Double End Bolts: To make sure have a good contact with the apparatus bushing.
2.Insulation: Moulded EPDM insulating rubber is formulated and mixed in-house to ensure high quality.
3.Insulating Lug: Molded epoxy insulating lug provides excellent electrical, thermal and mechanical reliabitity.
4.Test Point (Optional): Corrosion-resistant, conductive electrode provides consistent capacitive voltage for application of fault indicators and determining a circuit's state.
5.Test Point Cover: Amoulded EPDM conducting rubber cap provides a watertight seal and check circuit status.
6.Semi-conductive Insert: Moulded EPDM conducting rubber screen controls electrical stress.
7.Stress Relief: The configuration of the other screen and the cable adapter provide cable stress relief.
8.Grounding Hole: Moulded into the external EPDM exeternal screen for connection of an earthing wire.
9.Semi-conductive Shield: Moulded EPDM conducting rubber mates with the cable svreen to maintain screen continuity and ensure that the assembly is at earth potential.
10.Conductor Cable Lug: Aluminum compression connector is sized to ensure a cool running connector with maximum current transfer.

Installation

1.Without any special tools.
2.When finish the installation of elbow connector the power can be supply directly.

3.According to the installation instruction Sheet (any other special requirement, please contact our sales staff)